(06-15-2023, 02:00 PM)Ayydan Wrote:(06-15-2023, 01:59 PM)packocrayons Wrote:(06-15-2023, 01:57 PM)Ayydan Wrote: I could, but it'd likely cost more than one of these laser cut units by the end. You can get these units made in mild steel for about half the price, I just don't know where I could go to get it passivated
I do my heat treating in a wood stove.
Alternatively - you could talk me into the pottery kiln that's on my list
Getting access to a kiln would definitely make this a much more feasible task, but is the one your looking at able to get to temp to melt stainless?
not quite (2400F), but close. Do you need to melt it or just heat treat it? I can't get a quick answer on the temperature for passivating