I have 2 projects ongoing right now.
The first one is where I'm trying to be able to go from a picture of a top down sketch of a keyboard plate and convert it to an STL file that I can 3d print. Right now I'm still trying to figure out some of the CV stuff, and I'm still dreading generating the STL file.
The other one I'm working on is trying to build a somewhat smart reptile enclosure. The idea here is that I'll set up some temperature and humidity probes throughout some zones in the tank, as well as connect it so it can control heat sources, so that I can log and monitor the enclosure climate. Other thoughts included having some scales under the floor so I can track roughly where the animal is, reed sensors on the door so I can send an alert if it seems like it's been left open.
Not sure if either of these will actually get done, but they're interesting thoughts at least.
The first one is where I'm trying to be able to go from a picture of a top down sketch of a keyboard plate and convert it to an STL file that I can 3d print. Right now I'm still trying to figure out some of the CV stuff, and I'm still dreading generating the STL file.
The other one I'm working on is trying to build a somewhat smart reptile enclosure. The idea here is that I'll set up some temperature and humidity probes throughout some zones in the tank, as well as connect it so it can control heat sources, so that I can log and monitor the enclosure climate. Other thoughts included having some scales under the floor so I can track roughly where the animal is, reed sensors on the door so I can send an alert if it seems like it's been left open.
Not sure if either of these will actually get done, but they're interesting thoughts at least.