Navigation:   AyyWS Forum › Technology › 3D Printing › Plastic Recycling - Shredding

Plastic Recycling - Shredding

19 Replies, 3148 Views

packocrayons

   08-15-2023, 11:17 AM
Junior Member
#3
Why not press between two borosilicate glass sheets? It would make release easier, and you could use a spacer (feeler gauges because gauge blocks are expensive) to get an exact and reproducible sheet thickness.

Messages In This Thread
Plastic Recycling - Shredding - by Ayydan - 08-11-2023, 10:18 AM
RE: Plastic Recycling - Shredding - by Ayydan - 08-14-2023, 10:58 AM
RE: Plastic Recycling - Shredding - by packocrayons - 08-15-2023, 11:17 AM
RE: Plastic Recycling - Shredding - by Ayydan - 08-15-2023, 01:51 PM
RE: Plastic Recycling - Shredding - by Ayydan - 08-15-2023, 04:28 PM
RE: Plastic Recycling - Shredding - by Ayydan - 08-15-2023, 05:34 PM
RE: Plastic Recycling - Shredding - by Ayydan - 08-16-2023, 09:14 AM
RE: Plastic Recycling - Shredding - by Ayydan - 08-17-2023, 11:03 AM
RE: Plastic Recycling - Shredding - by Ayydan - 08-17-2023, 12:11 PM
RE: Plastic Recycling - Shredding - by Ayydan - 08-24-2023, 11:48 AM
RE: Plastic Recycling - Shredding - by Ayydan - 08-24-2023, 03:49 PM
RE: Plastic Recycling - Shredding - by Ayydan - 08-27-2023, 04:38 PM
RE: Plastic Recycling - Shredding - by Ayydan - 09-08-2023, 05:14 PM
RE: Plastic Recycling - Shredding - by Ayydan - 07-25-2024, 02:36 PM
RE: Plastic Recycling - Shredding - by Ayydan - 07-25-2024, 07:06 PM
RE: Plastic Recycling - Shredding - by Ayydan - 07-25-2024, 07:22 PM
RE: Plastic Recycling - Shredding - by Ayydan - 07-26-2024, 03:36 PM
RE: Plastic Recycling - Shredding - by Ayydan - 07-29-2024, 11:45 AM



Users browsing this thread: 1 Guest(s)